This week I would like to share a little bumper mod on the TLR 22 4.0, 22 4.0 SR, 22T 3.0 line of vehicles. Sometimes trying to install the rear toe-in block with the bumper can be a little tough and this mod helps with that. Frist remove the material shown in the picture below. With this material removed you can install the toe-in block first using the center 2x6mm Flat Head Screw then sliding the bumper into its location and then installing the two 3x12mm Flat Head Screws securing everything together.
JR
#22empire
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.