Hello everyone,
This week we’re back with the 1/10th side of
TLR and we are talking rear hub carriers. With the introduction of TLR’s new
Genll hub (TLR234075), people have had
some questions and concerns with this new part.
Question #1: “With the added aluminum top piece
on the hub, does this change my bull stud height?” Answer is no; take a look at
the picture below that shows a side-by-side view of a Genl hub and a Genll both
are the same height.
Question #2: “Is the added
aluminum top piece threaded?” Answer is no, and with this comes some info. Previously
an 8mm (TLR6024) length ball stud was all that was required for the Genl hubs
with the standard 2mm washer; now with the Genll hubs a 10mm (TLR6023) length
ball stud is required with the standard 2mm washer. This is needed because the
first 2mm of the Genll hubs are not threaded and extra thread support is
needed. Also to keep in mind if using 0 or 1mm spacers on the Genll hub, you
will need to go back to the 8mm as the 10mm will be too long for these
circumstances.
JR
#22empire
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.