Tuesday, October 15, 2019

My TLR 8IGHT XE electronics setup

Hello everyone,

This week, I would like to share my TLR 8IGHT XE electronics setup. After another great result here in Florida at the 1/8th FORCE series, I've received several requests to share what my electronics setup is and I thought it would be good info for here on the TLR Blog. Below I've outlined the manufacturer, equipment, and settings form this past Saturdays FORCE series event at Mills Pond in Fort Lauderdale, Florida.


Tekin equipment
T250 Servo 
1/8 RX8 Gen3 BL ESC 4030 T8 Gen3 BL Motor 1900kv Combo

Speedo settings
4cell (3.0 voltage cutoff per cell)
BL-FW

Drag Brake: 10
Brake Strength: 100
Push Control: Off
Brake Minimum: 0
RPM Brake: 2
Active Drag: On
Brake Frequency: 6kHz

Neutral Width: 25
Torque Level: 9
Reverse Speed: Off
Throttle Minimum: 3
Throttle Frequency: 8kHz

Timing Profile:1
Curves: 3

Trinity equipment
4S 14.8V 6000MAH 60C 1/8 E-BUGGY PACK WITH 5MM BULLETS
CERTIFIED ADJUSTABLE 5MM PURE COPPER GOLD PLATED BULLET CONNECTORS


JR
#22empire #8realm #DriveTLR

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.